Overview
SM Designs Presents the New 16 cue module tester for PD modules, The unit
tests all conditions of one or multiple modules in the shop or in the field, It
also will hold 2 firing scripts and test complete show Status,
This unit is the only tester of its kind on the market today and is a
necessity to anyone with a PD system.
Test your modules as you build your show and know where you stand before
running any cables.
Isolate bad modules in a snap.
An indispensable tool for equipment management.
The handheld unit can be carried easily on the shoot site.
|
Features
- Portable, lightweight and capable of one handed
operation.
- Measure the current drawn on each of the 2
power/communication lines of the 3-wire module interface.
- Detect overload conditions and limit the current
available to prevent igniters from being un-intentionally fired.
- Send sequential status requests to find attached
modules’ address. Stops on first reply and repetitively requests status.
- Retain module status information after power down.
- Download a firing script to store a list of modules
and pins used in either of 2 stored tables.
- Compare the module reply against the stored list to
detect any errors.
- Warning tone sounds when 3-wire interface buss
powers up.
- Display internal battery voltage.
- Low Battery warning and alarm tone.
- Auto power-off after set interval of inactivity.
- Powered from a single widely available 9V battery.
- Backlit sunlight readable 16 character 2 line text
display.
- Turns off display back light to conserve battery
life. Turn back light back on with any button press.
- Rugged plastic case with protective rubber boot to
protect from knocks and drops.
- Dust sealed front controls and display.
|
Specifications
9 Volt internal battery
3 Wire XLR cable
9 pin serial cable for Downloading scripts
Multiple baud rates
|
|
Pricing | |
|
3 Wire Module Tester for PD Modules | $595 |
