Specifications Smartfire Computerized Pyrotechnic Firing Controller
Self Contained 7.5 AMP, 24 Volt lead acid rechargeable gel cells Battery Charger can be powered by 120 VAC or 12 VDC car adaptor. Physical Built-in Battery Charge Meter SmartCharge monitors the battery and modifies its charge rate to charge quickly while also protecting from an overcharge. Firing Speed and Resolution: Exact simultaneous firing of multiple cues in
any number of modules 1/100 of a second for multiple cues in different modules 1/10 of a second for multiple cues in the same module Interfaces to computer via RS-232 serial or USB cable 32-bit solid state microprocessor for reliable operation LED indicators for short circuit, positive communication, and system state Dead man switch for emergency show stop and step fire trigger mode Arming key to prevent accidental show start Output to modules are gold plated industry standard 4-pin XLR connectors RS-485 Reliable Data Protocol used to communicate with components Industrial ABS weatherproof case Flexible neck work light inside case Windows 98
Second edition, 2000, XP compatible Designed to be controlled by the extremely powerful and flexible SmartShow software.
New
Model Features
LCD Text Display
Firmware and hardware reported on text display upon startup.
Arm condition Warning beep.
Battery level voltage indicated on Display.
Audible Low and very low alarm.
Text Warning for Low Battery.
Constant Current load numerically displayed.
XLR short Displayed.
24 Volt XLR output Led shows Short Status, Green Normal,
Yellow Moderate Load, Red Overload.
Test Status with Holdfire released.
Transmission and reception of signal indicated on COM Led.
Firing commands will give warning beep with holdfire released.
32-cue Self Contained Digital Smart Module (SM-32T)
Digital processor and terminals in a single unit 32 Terminals per module allow for 32 cues. About
10 e-matches in series per cue depending on lead length and brand. Each module has two XLR connectors which allow you to have multiple modules on the same wiring branch. Each module is still independently addressable. Input and Output are gold plated industry standard 4-pin XLR connectors 32-bit microprocessor receives data via the RS-485 Reliable Data Protocol Module mode switch selects Safe, Test, or Arm Multicolor LED indicates module mode Powered by the rechargeable batteries in the controller Power Booster Packs available to provide additional power in the field if needed for unlimited cable lengths. Industrial ABS weatherproof case
32 Cue Digital Economy Module (SM32E) Digital processor and terminals in a single unit
64 Terminals per module allow for 32 cues. (Speaker terminal type) About
10 e-matches in series per cue depending on lead length and brand. Each module has two XLR connectors which allow you to have multiple modules on the same wiring branch. Each module is still independently addressable. Input and Output are gold plated industry standard 4pin XLR connectors 32bit microprocessor receives data via the RS485 Reliable Data Protocol Module mode switch selects Safe, Test, or Arm Multicolor LED indicates module mode Powered by the rechargeable batteries in the controller Power Booster Packs available to provide additional power in the field if needed for unlimited cable runs
Powder Coated Aircraft Aluminum Case.
System Cables Gold Plated XLR 4-pin connectors Heavy duty, industry standard, 4-wire, 16 Gauge, rubber jacketed cables Available in a variety of sizes including 5', 10', 25', 50', 100', and 200' Smartfire Wireless Transmitter
Transmits data extremely reliably up to 1 mile to wireless receivers or modules
(In some cases, our customers have got up to 2 miles, line of sight) 2.4 Ghz Spread-spectrum technology with redundancy to eliminate errant radio interference. 32-bit microprocessor receives data via the RS-485 Reliable Data Protocol One transmitter can control up to 99 individual modules Can be used standalone or alongside wired system. Gold Plated XLR input Powered by the rechargeable batteries in the controller Weatherproof ABS case
32-cue Wireless Digital Smart Module (SM-32TW) Battery, Wireless receiver, digital processor, and terminals in a single unit Self Contained 2.9 AMP, 24 Volt lead acid rechargeable gel cells
Auto Power Up
In Range LED
64 spring loaded Terminals per module allow for 32 cues About 10 e-matches in series per cue depending on lead length and brand XLR port allows you to connect up to 5 additional wired modules (SM-32T) to be powered and controlled via this wireless module. Each one of these modules can then be individually addressed by the SmartFire controller. Output is gold plated industry standard 4-pin XLR connector 2.4 Ghz Spread-spectrum technology with redundancy to eliminate errant radio interference Module mode switch selects Safe, Test, or Arm Multicolor LED indicates module mode Secure key to switch power on or off Weatherproof ABS case

Heavy duty aluminum Module Cover Protect your modules from rain,
fire, and falling debris with this heavy duty Aluminum cover, made from 1/16"
aircraft aluminum, Large enough for any type module, splitter or booster pack.
Units are stackable for easy transport and are open on both ends for cables
and other wires .
FSK or SMTPE Timecode modem for Pyromusicals
Allows your computer to sync the show to music with embedded timecode Connects directly to laptop, not controller for reliability Timecode enters via RCA jack Computer connects via a Serial-USB cable, sold separately Receive Data LED allows you to quickly determine if you are receiving timecode effectively. Power is controlled via switch with LED Powered via 9 volt battery or 120v AC adapter Polystyrene plastic case
FSK Wireless Timecode modem for Pyromusicals 5 Mile Range
Allows Unlimited NightHawks to sync the show to music with embedded timecode
Connects directly to Sound source and transmits to multiple receivers. Timecode
enters via RCA jack Receive Data LED allows you to quickly determine if you are receiving timecode effectively. Power is controlled via switch with LED Powered via
12 volt battery or 120v AC adapter
Extruded Aluminum Case
Power Booster Packs
Adds additional power out in the field for larger shows with unlimited cable runs Gold Plated XLR
output Self-contained rechargeable battery power system with 7.5 AMP, 24 Volt lead acid rechargeable gel cells
and SmartCharge Keyed power switch with LED indicator Splitter
Allows you to have a tree topology with branches splitting from the trunk
6 Gold Plated XLR 4-pin connectors 1 XLR in and 1 XLR out for the trunk and 4 XLR ports for the branches Extruded Aluminum case
Active Splitter
Protects from system shutdown due to shorted cables.
Automatically disconnects shorted cable branch
Led indicator on all outputs
Allows you to have a tree topology with branches splitting from the trunk
9 Gold Plated XLR 4pin connectors 1 XLR in and 1 XLR out for the trunk and
7 XLR ports for the branches Extruded Aluminum
Case
XLR Cable Tester
Protect system from shutdown due to shorted cables.
Tests for proper continuity
Tests for shorts or crossover of conductors
Led indicator on all outputs
Internal Batteries 1-4 pin XLR male in and 1-4 pin XLR female out
Plastic Case
Digital adapter to convert legacy analog modules Digital processor without terminals for digital-analog conversion of almost any brand of rails or modules. For example, this allows you to convert an FM-45 to digital Smartfire communication. Custom physical cable converter not included, but available to your spec. Each adapter has two XLR
connectors which allow you to have multiple modules on the same wiring branch. Input and Output are gold plated industry standard 4-pin XLR connectors 32-bit microprocessor receives data via the RS-485 Reliable Data Protocol Module mode switch selects Safe, Test, or Arm Multicolor LED indicates module mode Powered by the rechargeable batteries in the controller Power Booster Packs available to provide additional power in the field if needed for unlimited cable runs Industrial ABS weatherproof case
Test Lamps Bag of 100 $25.00

|